President Luis Munoz
Member AMA
flycubs@comcast.net
page 3


Once the bottom sheeting was complete I added a block in the center to
 use as the leading edge hold fast.  I also added the rails for the
 aileron servos. 
I then added the top sheeting and did some light sanding. 

Next came the trailing edge sheeting
 and the rib caps. 


I made the ailerons, cut the hinge slots and attached them to see how
 
 the wing was looking.


It did not take too much time to knock out the tail feathers.  The
 ruder and elevator are built up from 3/16 square and 3/16 x 5/16 stock.  
I cut and pinned down the 3/16 x 5/16 stock and began cutting and pinning
 right on top of the plans.  Then I glued it all with thin CA.  I had
 the ruder and elevator done in about a half hour.


Now it’s time to cut out the F1, F2, and F3 bulk heads along with the
 firewall.  Only F3 was built up, the rest were cut from 1/8 light ply.
 Well, the time had come to mark the plans up a bit.  This plane was
 suppose to be a center wing as you can see from the plans, but I wanted it
 to be a shoulder wing in order to make room for a battery under the
 wing.  I simply placed the completed wing on the plans and drew the
 outline where I wanted the wing to go.  This worked out for this plane as
 there are no wing tips. 



back to project page
  Back to Home page
page 1
page2
page3
page4
PAGE5
page6